Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a little however, it's still attractive. It might not be the most luxurious car in its class It's a Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's still a pleasant and a civilized drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. These tips can help whether the problem is intermittent, or constant.

Water Damage

If you accidentally drop your key fob into the puddle, or it gets wet while kayaking canoeing, rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry bag whenever you are outside or perform activities that expose it to large amounts of water.

You'll also want to ensure that the fob is completely dry before opening it up and using it again. If you smell any odors from the fob (such as industrial fluid or windshield washer fluid) it is a sign that it has been submerged.

A wet circuit may cause the battery's charge to be drained or even explode. If you're able to pull your key fob 308 out of whatever body of water it got stuck in it, flip the button side down and shake out as much water as you can before opening the case. Take the battery out, and then clean the circuit board using a cotton swab that is dipped in 90 percent alcohol.

Other reasons why your peugeot key replacement 308 remote entry keyless system may not work could be due to a dead coin-cell battery or receiver module issues signal interference, or a malfunctioning chip. If none of the above are the reason, you may try resetting the system by disconnection of the battery that is 12 volts for around 15 minutes.

Dead Coin Battery

peugeot key cars come with a remote start system that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to getting in. This feature is very useful, Peugeot 308 key fob especially in the cold winter months. Remote start systems can stop working for a variety reasons, including a dead coin-battery.

A coin-shaped battery that is in the key fob will last a time of between two and four years, based on how often it is used and where it's purchased. The date for use-by is typically written on the package or in the manual.

If the key fob stopped functioning after being exposed to clean tapwater, take out the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then, dry the chip thoroughly before replacing. If you expose it to soapy or salty water, the chip might be fried and you will require replacing the key fob completely.

If you're unsure whether the battery is in good condition, you can check its voltage using a multimeter that is connected to both the terminals plus and minus. The voltage should be around 12 to 13 volts, but if it's lower, then the battery needs to be replaced. Alternatively, you can try to reset the on-board computer by disconnecting the battery at 12 volts for a few minutes and reconnecting it in reverse order (positive cable first followed by negative). The engine should now start.

Faulty Receiver Module

If you aren't seeing the "Key Detected", it could be that your receiver module is faulty. It is the part which sends out an alert when the key fob goes off. It also functions as an alarm and blocks the car from starting if you don't have the correct key.

This can be due to many factors, including water damage or just getting old. If your Peugeot 308 key fob was exposed to dirty tap water, for Peugeot 308 key fob instance the electronic chip inside may be damaged. In this scenario you'll need to remove it apart and clean it thoroughly with isopropyl alcohol or electronic cleaner. When the battery is clean, you can try again.

If the problem persists, it's probably a good option to consult a local Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to assist in identifying the problem and repair it for you.

The loss of your Peugeot car keys could be an emotional experience. However, a trained auto locksmith can resolve the issue in a matter of minutes. They can cut a new key for peugeot 207 key and then program it into your vehicle, ensuring that you're out on the road as quickly as possible. Click here to find a locksmith near you.

Faulty electronic chip

The chip inside your Peugeot 308 key fob is an crucial component of the remote control system. If the chip is damaged, you may have problems starting your car or receive a message saying "anti-theft". In this instance the only option is to replace the key. Luckily, professional auto locksmiths are able to provide this service in the shortest time.

The chip inside the key fob of your Peugeot 308 may become faulty for a variety of reasons, such as water damage, sweat or dirt. If your peugeot car key 308 key fob has been exposed to soapy water, you should cleanse it immediately. You can wipe the electronic component with paper towels soaked with isopropyl Alcohol. The battery must then be allowed to fully dry.

Radio interference can cause the key fob to stop working. This can happen when other devices operate on the same frequency as your Peugeot keyfob. It could also be caused by bad weather or objects around the vehicle. If you have this issue it is advised to visit the Peugeot dealership.

The Peugeot 207/308 key fob is very delicate and requires extra attention. You shouldn't drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Disconnect the negative cable prior to the positive.