Replacing uPVC Window Handles

The replacement of window handles made of upvc is a fairly straightforward job. It is important to make sure that the new handle is fitted into the spindle cutouts in the window mechanism.

If the steps listed below are followed properly the cockspur handle will fit most windows. The most important factor is the step size of the handle.

What to Look for

A large portion of windows in the UK come with uPVC handles, and over time they will begin to show signs of wear and tear. When this occurs, the window handle could become shaky or difficult to operate, which makes it essential to replace it. Anyone who is proficient with basic hand tools can complete this relatively simple job.

The first step is to ensure that the handle is firmly connected to the window frame and is in the open position. The next step is to locate the fixing screws or pins that hold the handle in place. These are usually located on the inside of the handle. They can be removed with an screwdriver or pliers.

Once the handle is loose it can be taken from its hinges by gently pulling it off. It is then necessary to locate a replacement handle that is the same design and size. This can be done in a DIY store or online. The process should take only five minutes and a screwdriver is all you need.

When replacing the handle of a uPVC handle it is essential to consider the step height. This is the distance between the handle's base and the place it sits in the frame of the window. This is a typical measurement and you should confirm the step height before ordering the replacement handle.

Depending on the type of handle you are using There are various sizes that are available. Inline handles for uPVC windows typically have 31mm lug centres There are also cockspur handle types with 43mm centres. Tilt and turn handles are typically used on windows made of uPVC, and they have a special design that allows windows to be slid up for ventilation, and then rotated to open the window fully.

The most common cause of breakage in uPVC handles is that they crack internally instead of breaking away from the base section. This can make it difficult to open. It is important to ensure that the replacement handle is fitted with the same spindle that was used in your original one.

Remove the handle that was previously used

Incorrectly installed or damaged window handles may cause your double glazed window handles-glazed windows to open or close incorrectly, and can result in them becoming stuck. This can be caused by various reasons, including general wear and tear on the handle or corrosion. In these situations it is crucial to replace the upvc window handle as quickly as you can in order to prevent further damage or loss of functionality.

When replacing the handles on windows made of upvc, you should remove the old handles from the window. To do this, start by taking off the screw that is encased when the handle is in the closed position. This should reveal another screw and once removed, you are able to begin to take off the handle itself. You can make the job simpler by using an electric screwdriver.

It is also important to note that the screws on the handle could be hidden behind caps made of plastic, so it is a good idea to take an Stanley knife to the screw caps and then take them off. After the handle has been removed, you should then look at the square cut out at the handle's base to ensure that the new window lock handles will work with it. It is crucial to measure the spindle length on the old handle and compare it to the dimensions of the window mechanism spindle cutout.